This site uses cookies to provide an optimized shopping experience. By using this site, you agree the use of cookies within our privacy policy.
Desco 19656
Dual Operator Monitor, Universal Power Adapter
The Desco 19656 Dual Operator Continuous Monitor is a workstation continuous monitor. It continuously monitors the path-to-ground integrity of two operators and one ESD worksurface.
- 100-240VAC Safety Certified Power Adapter with IEC C14 Style Inlet
- Dual Operator Workstation Continuous Monitor Continuously monitors the path-to-ground integrity of two operators and one ESD worksurface
- Wave Distortion Technology
- Improved Operator Alarm
- 100-240VAC Safety Certified Power Adapter with IEC C14 Style Inlet
- Dual Operator Workstation Continuous Monitor Continuously monitors the path-to-ground integrity of two operators and one ESD worksurface
- Wave Distortion Technology
- Improved Operator Alarm
- Park Delay Timer
- Visual Status Display Displays the operators' and worksurface status: illuminates red when intermittent or failed connection occurs
- Mat Monitor Switch Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface
- Audible Alarm Adjustment Sets the audible alarm volume from loud to louder
- Park Snap Allows the operator to disconnect (and park) a wrist strap when leaving the workstation without creating a false alarm
- Single-wire Impedance Design
- 1.2 Volt Operator Test Voltage
- <50 Millisecond Alarm Response Time
- Calibration Verification
- NIST Calibrated
The Desco 19656 Dual Operator Continuous Monitor is a workstation continuous monitor. It continuously monitors the path-to-ground integrity of two operators and one ESD worksurface. Mounting tabs make it suitable to install in workbench or equipment settings, and the Visual Status Display can be placed to increase alarm visibility. It may be connected to the 19323 Power Relay accessory to control power to electronic devices at the workbench dependent on the continuous monitor's status.
The 19656 Dual Operator Continuous Monitor is designed with Wave Distortion Technology to provide stable continuous monitoring of the path-to-ground and presence of 1 megohm resistance of an operator's wrist strap. Audio and visual alarms activate (in less than 500 milliseconds) when the operator unintentionally disconnects from the monitor, or the wrist strap connection points are intermittent. The 19656 also monitors for a worksurface path-to-ground of less than 10 megohms and the integrity of the electrical ground used to by the monitor All Dual Operator Continuous Monitors are calibrated to NIST standards.
Country of Origin | United States |
---|---|
Brand | Desco |
Condition | NEW |
Vendor Alias | 19656 |
- 1 - Dual Operator Monitor, Universal Power Adapter (19656)
- 1 - Visual Status Display
- 1 - Modular Cable, 7' Length
- 1 - Mat Monitor Cord (White)
- 1 - Countersunk Washer
- 1 - Flat Head Screw, 6-32 x 1/4"
- 4 - Pan-Head Screw, #6 x 3/8"
- 2 - Dual Lock Fastener Set, 2" Length
- 2 - 10mm Interchangeable Park Snap
- 2 - 10mm Operator Jack Adapter
- 1 - Power Adapter with IEC C14 Inlet, 9 VDC