The Fluke Networks MT-8200-61-TNR IntelliTone Pro 200 LAN Toner is a digital and analog tone generator that verifies and troubleshoots virtually any copper cabling in datacom and telecom networks - identifying the type of service, testing for Line 1 and Line 2 polarity and ring, and verifying continuity - and its F-type connector supports VDV cables including RJ45, RJ11, coaxial, and bare wire while its banana jacks accommodate test leads. It identifies and diagnoses 10/100 Gigabit Ethernet link connectivity with NIC (network interface card)/hub indication as well as Line 1 and Line 2 POTS (plain old telephone service). The Fluke Networks MT820061TNR IntelliTone Pro 200 LAN Toner generates IntelliTone digital signals that minimize the effect of signal bleed for locating high-grade data cabling (Cat 5e/6/6a) on active networks, and generates 500 to 1,200 Hz analog signals with four distinct SmartTone songs for isolating individual wire pairs and locating voice, audio, and video cabling (Cat 3 and below) on inactive networks. The MT820061 TNR IntelliTone signals can be detected by Fluke Networks devices such as the Intellitone Pro 200 Probe (sold separately). LED indicators identify a jack as datacom, telecom, or dead. The unit turns off automatically after 2.5 hours of inactivity. It comes with an RJ11-to-RJ11 patch cord, RJ45-to-RJ45 patch cord, a test lead set with banana jacks to alligator clips, a female-to-female F-type connector adapter, a 9V alkaline battery, and a quick start guide. Additional specifications include various environmental operating conditions. The toner provides all of these capabilities when used with the compatible Fluke Networks IntelliTone Pro 200 Probe (MT-8200-63A) only.